GMRES(m) in CULA Sparse S4

General CULA Sparse support and troubleshooting. Use this forum if you are having a general problem or have encountered a bug.

GMRES(m) in CULA Sparse S4

Postby gregk » Sun May 19, 2013 2:43 am

i could make my question, in my previous topic, but this time is quite more general and i thought that this will might help other users too.

So i am using GMRES(m) as my iterative solve, and i noticed that in Cula_Result the solver is mentioned as GMRES(5). From my knowledge i expect that this m must be the restarts defined in the Gmres_SolverOpts, but i've tried a lot of values for restart and that GMRES(5) stays the same.

So my question is : Does CULA interally increase this m until it accomplishes the required convergence? Or in other words: Where can i see on which restart GMRES converged?

Thanks in advance
Posts: 9
Joined: Thu Apr 18, 2013 3:28 am

Re: GMRES(m) in CULA Sparse S4

Postby john » Mon May 20, 2013 6:21 am

I can't readily comment on S4 any further, but would be curious to see if this problem exists when you try S5.

In general though, m is the value for "restart" in the GMRES options. In S5 (can't recall about S4), "iterations" were defined as the number of restarts.
Posts: 587
Joined: Thu Jul 23, 2009 2:31 pm

Return to CULA Sparse Support

Who is online

Users browsing this forum: No registered users and 1 guest